Perko 8501DP Battery Selector Switches

Use two switches for dual engine systems. Dimensions: 5-1/2" dia. 2-5/8" depth. Capacity - 250 amps continuous, 360 AMPS Intermittent. Ignition Protected. For use with 12, 24 and 32 Volt Marine Electrical Systems. For use with systems under 50 volts. Capacity: 250 amps continuous, 360 Amps Intermittent. For use with two or more batteries and single or dual engine systems.

Built with quality materials. When used with non-unitized alternators, these models will interrupt the field current reducing the possibility of damage if turned "OFF" with the engine running. They permit selection between batteries for starting and charging or operation of both batteries in parallel.

---

Blue Sea Systems ST Blade Fuse Block - 12 Circuits with Negative Bus & Cover

Fuses sold separately. Accepts ato and ATC fast acting blade fuses. Cover satisfies abyc/uscg requirements for insulation, incorporates an easy to open push button latch providing easy access to fuses, storage for two spare fuses. Can be used for 24-hour circuits. Fuse block, mfg# 5026, atc/ato, w/negative bus and cover, 12 circuit, 32VDC max W/30Amp max per circuit & 100Amp per block.

Positive distribution bus with #10-32 stud. 3. 32"w x 6. 5"h x 1. 52"d. St blade fuse block - 12 circuits with negative bus and cover.


Similar products

---

T-H Marine Supplies Dual Holder Tray Boating Battery Chargers

It distributes an ever increasing array of proven hunting and shooting sports products, along with an incredible selection of marine products from trusted vendors. It distributes an ever increasing Array of Proven hunting and Shooting sports products, along with an incredible selection of marine products from trusted vendors.

St blade fuse block - 12 circuits with negative bus and cover. Accepts ato and ATC fast acting blade fuses. Our product lines include firearms, marine electronics, Cutlery, archery equipment, reloading, trolling motors, optics, ammunition. Manufactured in United States. Cover satisfies abyc/uscg requirements for insulation, incorporates an easy to open push button latch providing easy access to fuses, storage for two spare fuses.

Positive distribution bus with #10-32 stud. Our product lines include firearms, marine electronics, trolling motors, archery equipment, cutlery, reloading, optics, ammunition. Manufactured in United States. Can be used for 24-hour circuits.


Similar products

---

Blue Sea Systems Common 150A 10-Gang BusBar with Cover

Max voltage: 300v aC/ 48V DC. 2 mounting holes accept #10 M5 screws. Continuous rating: 130A AC/ 150A DC. St blade fuse block - 12 circuits with negative bus and cover. Accepts ato and ATC fast acting blade fuses. The industry standard busbar for positive or negative power distribution Bus material - Tin platted Copper CDA 110/UnS C1100 Insert molded stainless steel studs eliminate need for securing nut and allow high torqueing electrical contact.

Our product lines include firearms, optics, archery equipment, marine electronics, trolling motors, reloading, cutlery, ammunition. Manufactured in United States. Cover satisfies abyc/uscg requirements for insulation, incorporates an easy to open push button latch providing easy access to fuses, storage for two spare fuses.

It distributes an ever increasing Array of Proven hunting and Shooting sports products, along with an incredible selection of marine products from trusted vendors. Can be used for 24-hour circuits. Positive distribution bus with #10-32 stud. Reinforced polycarbonate base with tin plated pure electrical copper for maximum conductivity.

150a common busbar with 10 screws and a cover.


Similar products

---

Ancor 121510 Marine Grade Duplex Cables, 14/2 AWG 2 x 2mm², Flat, 100ft

St blade fuse block - 12 circuits with negative bus and cover. Can be used for 24-hour circuits. Positive distribution bus with #10-32 stud. Manufactured from individual copper strands and tinned to perform in the harshest marine environments. Ultra-flexible type 3 stranding resists fatigue from vibration and provides added corrosion protection.

Exceeds all ul 1426, us coast guard charter boat CFR title 46 and ABYC standards. 2 mounting holes accept #10 M5 screws. The premium vinyl insulation is rated at 600 volts, heat, oil, battery acid, stays flexible even in extreme cold -40 deg F/C and resists salt water, gasoline, 105 deg C dry and 75 deg C wet, abrasion and ultra-violet radiation.

150a common busbar with 10 screws and a cover. It distributes an ever increasing Array of Proven hunting and Shooting sports products, along with an incredible selection of marine products from trusted vendors. Exclusive insulation rated at 600V, 105 C. Max voltage: 300v aC/ 48V DC. Premium vinyl insulation stays flexible even in extreme cold & resists saltwater, battery acid, oil, gasoline & UV radiation.

Accepts ato and ATC fast acting blade fuses. Continuous rating: 130A AC/ 150A DC. Outer jacket made for easy removal & abrasion-resistance.


Similar products

---

Attwood Battery Tray- 24 Series

Positive distribution bus with #10-32 stud. A simple-to-install battery holder that fits into a limited space. It distributes an ever increasing Array of Proven hunting and Shooting sports products, along with an incredible selection of marine products from trusted vendors. For batteries up to 10-1/2" in height.

Molded base mounts with four #10 panhead screws. Max voltage: 300v aC/ 48V DC. 2 mounting holes accept #10 M5 screws. Cover satisfies abyc/uscg requirements for insulation, incorporates an easy to open push button latch providing easy access to fuses, storage for two spare fuses. Continuous rating: 130A AC/ 150A DC.

The premium vinyl insulation is rated at 600 volts, battery acid, oil, gasoline, 105 deg C dry and 75 deg C wet, heat, stays flexible even in extreme cold -40 deg F/C and resists salt water, abrasion and ultra-violet radiation. Inside dimensions: 7" l x 11" W, Battery Series: 24/24M. 150a common busbar with 10 screws and a cover.

Our product lines include firearms, marine electronics, trolling motors, cutlery, archery equipment, reloading, optics, ammunition. Manufactured in United States. Can be used for 24-hour circuits. Accepts ato and ATC fast acting blade fuses.


Similar products

---

Attwood Battery Tray- 27 Series

12-3/8 inches l x 7-1/8 inches w. Accepts ato and ATC fast acting blade fuses. The premium vinyl insulation is rated at 600 volts, 105 deg c dry and 75 deg C wet, heat, stays flexible even in extreme cold -40 deg F/C and resists salt water, gasoline, oil, battery acid, abrasion and ultra-violet radiation.

Inside dimensions: 7" l x 11" W, Battery Series: 24/24M. The polypropylene hold-down strap has a positive locking, quick disconnect buckle. Continuous rating: 130A AC/ 150A DC. It distributes an ever increasing Array of Proven hunting and Shooting sports products, along with an incredible selection of marine products from trusted vendors.

Battery series 27/27M. A simple-to-install battery holder that fits into a limited space. The polypropylene hold-down strap has a positive locking, quick disconnect buckle. Our product lines include firearms, marine electronics, trolling motors, cutlery, archery equipment, reloading, optics, ammunition. Manufactured in United States.

For batteries up to 10-1/2" in height. Molded base mounts with four #10 panhead screws. A simple-to-install battery holder that fits into a limited space.


Similar products

---

Perko 9601DP Battery Disconnect Switch

Molded base mounts with four #10 panhead screws. Can be used for 24-hour circuits. The polypropylene hold-down strap has a positive locking, quick disconnect buckle. For batteries up to 10-1/2" in height. Provides simple installation for changing or replacing batteries. A simple-to-install battery holder that fits into a limited space.

A simple-to-install battery holder that fits into a limited space. For batteries up to 10-1/2" in height. 2 mounting holes accept #10 M5 screws. And as ignition protected switches, they can be installed in the engine rooms of gasoline powered boats. Ignition Protected. Molded base mounts with four #10 panhead screws.

27 series Tray. Perko's 9601 series battery On-Off switches are among the most popular battery switches ever produced. Accepts ato and ATC fast acting blade fuses. The premium vinyl insulation is rated at 600 volts, oil, heat, 105 deg C dry and 75 deg C wet, battery acid, gasoline, stays flexible even in extreme cold -40 deg F/C and resists salt water, abrasion and ultra-violet radiation.

Inside dimensions: 7" l x 11" W, Battery Series: 24/24M. 12-3/8 inches l x 7-1/8 inches w.


Similar products

---

NOCO BT31S Group 24-31 HD Battery Tray for Automotive, Marine and RV Batteries

The polypropylene hold-down strap has a positive locking, quick disconnect buckle. St blade fuse block - 12 circuits with negative bus and cover. The premium vinyl insulation is rated at 600 volts, 105 deg c dry and 75 deg C wet, gasoline, battery acid, oil, heat, stays flexible even in extreme cold -40 deg F/C and resists salt water, abrasion and ultra-violet radiation.

Inside dimensions: 7" l x 11" W, Battery Series: 24/24M. All noco extreme-duty battery trays meet United States Coast Guard USCG Code of Federal Regulations 183. 420 and american boat and Yacht Council ABYC E-107 specifications. Ignition Protected. The polypropylene hold-down strap has a positive locking, quick disconnect buckle.

Continuous rating: 130A AC/ 150A DC. Battery series 27/27M. Certified and tested; meets united states coast guard usCG Code of Federal Regulations 183. 420 and american boat and Yacht Council ABYC E-107 specifications. Extreme-duty battery tray for Automotive, Marine, RV batteries and more; designed for a single group 24-31 battery.

The noco extreme-duty battery trays include a 42 inches military grade battery hold-down strap, which is made for a water resistant nylon material and withstands tensile loads of over 120 kilogram force.


Similar products

---

99.9% Oxygen-Free Copper Set - InstallGear 5 AWG Gauge 10ft Battery Power Inverter Cables for Solar, Auto, RV & Marine

Designed for abuse; impact resistant down to minus 20 degrees Fahrenheit, withstands acid, gas, oil and other contaminants, and immune to UV exposure. Keeps your battery safe; keeps your battery securely mounted and limits battery movement with its included battery strap. 10ft of 5 gauge inverter cable set pure ofc copper wiring - for maximum power transfer includes: 2 3/8" and 2 5/16" ring terminals only 1 end has been crimped to allow adjustments Each cable end is sealed with heat shrink tubing to minimize corosion only 1 end has tubing applied to allow adjustments These cables are true spec with a rugged PVC jacket for ultimate protection St blade fuse block - 12 circuits with negative bus and cover.

10ft of 5 gauge inverter cable set. For batteries up to 10-1/2" in height. Manufactured from individual copper strands and tinned to perform in the harshest marine environments. Ultra-flexible type 3 stranding resists fatigue from vibration and provides added corrosion protection. Exceeds all ul 1426, us coast guard charter boat CFR title 46 and ABYC standards.

Continuous rating: 130A AC/ 150A DC. Military grade battery hold-down strap; 42 inches water resistant nylon webbing and heavy-duty buckle withstands a tensile load of over 120 kilograms force. Certified and tested; meets united states coast guard usCG Code of Federal Regulations 183. 420 and american boat and Yacht Council ABYC E-10




Similar products

---

White 3M Marine 5200 Adhesive / Sealant 10 fluid ounce cartridge

For batteries up to 10-1/2" in height. Provides simple installation for changing or replacing batteries. Built with quality materials. Very high strength. 3m, polyurethane, 1/10 gallon cartridge, retains strength above or below water lines, does not sag or flow in vertical or horizontal zontal seams, completely cures in 5 to 7 days with no shrinkage, tack free in 48 hours, #5200 marine adhesive/sealant, bonds & evenly, excellent resistance to weathering & seals fiberglass & most woods, white, applies smoothly & Salt water.

Molded base mounts with four #10 panhead screws. The polypropylene hold-down strap has a positive locking, quick disconnect buckle. Battery series 27/27M. A simple-to-install battery holder that fits into a limited space. Our product lines include firearms, optics, marine electronics, trolling motors, reloading, cutlery, archery equipment, ammunition.

Manufactured in United States. Pure ofc copper wiring - for maximum power transfer. 10ft of 5 gauge inverter cable set. Max voltage: 300v aC/ 48V DC. Easy Installation.


Similar products